Questions
ayuda
option
My Daypo

ERASED TEST, YOU MAY BE INTERESTED ONFAA AMT AIRFRAME QUESTIONS 14

COMMENTS STATISTICS RECORDS
TAKE THE TEST
Title of test:
FAA AMT AIRFRAME QUESTIONS 14

Description:
faa study guide

Author:
fabio santos
(Other tests from this author)

Creation Date:
14/08/2017

Category:
Others

Number of questions: 10
Share the Test:
Facebook
Twitter
Whatsapp
Share the Test:
Facebook
Twitter
Whatsapp
Last comments
No comments about this test.
Content:
The altitude controller maintains cabin altitude by modulation of the, safety and outflow valves. safety valve. outflow valve.
Why is it necessary to use flux in all silver soldering operations? To chemically clean the base metal of oxide film. To prevent overheating of the base metal. To increase heat conductivity.
Other than the manufacturer maintenance manual what other document could be used to determine the primary flight control surface deflection for an imported aircraft that is reassembled after shipment? Aircraft type certificate data sheet. Import manual for the aircraft. The certificate of airworthiness issued by the importing country.
The generator rating is usually found stamped on the, firewall. generator. engine.
The operation of an angle-of-attack indicating system is based on detection of differential pressure at a point where the airstream flows in a direction, not parallel to the true angle of attack of the aircraft. parallel to the angle of attack of the aircraft. parallel to the longitudinal axis of the aircraft.
How many of the following are controlled by gyroscopes? 1. Attitude indicator. 2. Heading indicator. 3. Turn needle of the turn-and-slip indicator. Three. Two. One.
(Refer to Figure 13 .) Determine what unit is located immediately downstream of the expansion valve in a freon refrigeration system. Condenser. Compressor. Evaporator coils.
When balsa wood is used to replace a damaged honeycomb core, the plug should be cut so that, the grain is parallel to the skin. it is about 1/8 inch undersize to allow sufficient bonding material to be applied. the grain is perpendicular to the skin.
Internal leakage in a brake master cylinder unit can cause, fading brakes. slow release of brakes. the pedal to slowly creep down while pedal pressure is applied.
How is a shunt wound dc generator connected? One field is shunted across the other. Both fields are shunted across the armature. The field and armature are shunted with a capacitor.
Report abuse Consent Terms of use